Replacement Monitor and Transmitter for the Roadmaster Even Brake System
Updated 03/22/2013 | Published 03/20/2013
Question:
I need a replacement for the LCD monitor Part 9410 that goes inside the RV. Do I also need to replace anything else so it will communicate with the car?
asked by: R. C
Expert Reply:
As long as the transmitter in the vehicle is still transmitting properly then you will not need any additional parts other than the replacement monitor # RM-9410 that you have referenced. If the transmitter is not sending out the signal then you can get both the monitor and transmitter together, # RM-9430. And if it is just the transmitter that is the problem you would need # RM-9420.
Product Page this Question was Asked From
Replacement Receiver for the Roadmaster Even Brake Braking Monitor
- Accessories and Parts
- Flat Tow Brake System
- Brake Monitoring
- Transmitters
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does the Roadmaster Universal Brake Monitor Come with an Actuator Arm
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Q&A: Will The New Replacement Command Center Hub for Curt RVi Series 4 Work on a Series 3
- Q&A: Replacement Command Center Hub for the Curt RVi Series 3 Portable Flat Tow Braking System
- Q&A: What Replacement Command Center Hub do I Need for My RVi Shadow Braking System?
- Q&A: Recommended Curt Flat Tow Braking System for a 2018 Ford F-150
- Q&A: Does Breakaway System for Flat Tow Supplemental Braking Need to be Added Separately
- Q&A: 2014 Honda CR-V Flat Towing Preparation Steps
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: RV-Mounted vs Vehicle-Mounted Tow Bars
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2016-2018 Ford Focus
- Article: How to Measure for Trailer Hitch Drop