Ultra-Fab UF48-979008 Lock Won't Fit on King Pin With Lube Plate Installed
Updated 04/15/2021 | Published 04/13/2021 >
Question:
With a lube plate installed, the sleeve wont fit properly. I dont want to have to take the lube plate off each time I want to use the lock. Any suggestions?
asked by: David B
Helpful Expert Reply:
Other than removing the lube plate (which you understandably don't care to do), if I were in your situation, I'd use an angle grinder to take a small amount of material off of the sleeve of the # UF48-979008 king pin lock to reduce its height. If you were to take about 1/8 of an inch off the height of the sleeve, it will work just fine with a lube plate.
Product Page this Question was Asked From
Ultra-Fab 5th Wheel King Pin Lock
- King Pin Locks
- Keyed Unique
- Steel
- Silver
- Ultra-Fab Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Should Weigh Safe Leveling Kit with Wheel Chocks Sit Under All Four Tires
- Q&A: What is the Diameter of the Lock Hole on the Demco Gooseneck Coupler Lock - 30K?
- Q&A: What is the Difference Between the Red and Yellow Trimax King Pin Locks?
- Q&A: Recommended Wireless Observation Cameras and Monitor for a Motorhome
- Q&A: Recommended Lock for MORryde GooseTech 5th Wheel to Gooseneck Pin Box
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Recommended Theft Protection For A Watchdog Surge Protector
- Q&A: Recommended Front Hitch for a 2023 Ford Transit T250 Eco-Boost
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: RV Electrical Power Systems
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices


