How To Trim Plastic Bumper Fascia On 2020 Buick Encore When Installing Curt Hitch Receiver C94UR
Updated 04/06/2021 | Published 04/05/2021
Question:
2020 buick encore gx, curt class 1 hitch. I see in the chevy video that the rear bumper fascia needs trimmed. Do you have some type of measurements or paper guide for me to use? Thanks
asked by: Craig M
1
Helpful Expert Reply:
When installing the Curt Trailer Hitch Receiver # C94UR, you need to trim a 2-5/8" wide by 1-3/8" tall square into the underbody panel as seen in the instructions that I attached for you. I also attached a section of the instructions that shows exactly where to cut the plastic panel.
expert reply by:
Andrew N
1
Curt C94UR Panel Trimming
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch for a 2024 Chevrolet Trailblazer
- Q&A: Recommended Brake Controller and Wiring Harness for a 2025 Toyota Tacoma
- Q&A: Trailer Hitch Receiver Fit For 2021 Chevy TrailBlazer
- Q&A: Recommended Trailer Hitch Receiver For A 2025 Chevy Trailblazer
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Q&A: Curt vs. Draw-Tite Trailer Hitch Receivers For 2025 Chevy Trailblazer
- Q&A: J-Case Fuse Position For Curt 7-Way Harness On 2024 Honda Pilot Blocked
- Q&A: Is There A Rebuild Kit Available For A Blue Ox Avail Tow Bar
- Article: How to Choose the Right Trailer Hitch Class
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Best Bike Racks for Electric Bikes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)