Will JT's Strong Arm Stabilizer LC191025 Fit A 2021 Grand Design Transcend Xplor W/ Angled Jacks?

Updated 04/05/2021 | Published 04/02/2021

Products Featured in This Question

JT's Strong Arm Jack Stabilizer Kit for Travel Trailers

(128)

$404.42

Ultra-Fab Chock and Lock Wheel Stabilizer for Tandem-Axle Trailers and RVs - Up to 5-1/4" Wide

(195)

$64.17

Question:

I am trying to see if this Strong Arm stabilizer system will work with my new trailer. A 2021 Grand Design Transcend Xplor 297QB. All photos show the scissor jack stabilizer being inline with each other from driver to passenger side in perspective. My trailer has the scissor jacks at an angle at the four corners of the trailer. Will a system like this work? Or is there one out there designed for my setup? Do I just adjust where my stabilizers are located?

asked by: JOHN S

Expert Reply:

It is possible that the JT's Strong Arm Jack Stabilizer Kit for Travel Trailers # LC191025 will work with your angled scissor jacks but only if there is a crossmember rearward of the rear jacks at a minimum of 4” to a maximum of 18”, and locate a cross-member or center compartment with a steel floor from 6”-18” from front of front jacks.

If you do not have a crossmember in these locations the best option would be to use the Ultra-Fab Chock and Lock Wheel Stabilizer for Tandem-Axle Trailers and RVs- Up to 5-1/4" Wide # UF21-001060 instead.

I included videos for each of the products mentioned for you to take a look at.

expert reply by: Samuel C