How to Mount the D-Ring to a MC10 Motorcycle Trailer for Strapping in a Honda Goldwing
Updated 03/07/2013 | Published 03/04/2013
Products Featured in This Question
Question:
How to install the D ring to the alluminion deck?
asked by: Richard P
Expert Reply:
You would need to drill a hole that is 4-3/8 inches in diameter for the base to fit through and then use nuts and bolts appropriate for the surface it is mounted to in order to secure it.
It is recommended to use the backing plate # BP06 under the surface where the D-Ring is installed to maximize its capacity and offer support. In order to drill out the hole you can use a large enough hole saw drill bit or use the backing plate as a template and a pencil to mark the diameter needed and use a cutting tool capable of making a hole if a hole saw bit is not available.
I would recommend you check the underside of the aluminum deck before you drill to determine the best possible location that will not interfere with any bracing or other trailer components.
Product Page this Question was Asked From
Brophy Swiveling D-Ring Tie Down Anchor - Bolt-On - 6-5/16" Wide - Recessed Mount - 2,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 2000 lbs
- Bolt-On
- Swiveling
- Recessed Mount
- Brophy
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Video: Installation Guide for the Curt Trailer Hitch Receiver on a 2024 Subaru Outback Wagon
- Video: Installation: etrailer Trailer Hitch Receiver on a 2022 Subaru Outback Wagon
- Shop: Roof Rack
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Front Runner Slimsport Platform Rack - Fixed Mount - 58" Long x 45-1/8" Wide
- Video: DIY 2021 Subaru Outback Wagon Installation for the Curt Trailer Hitch Receiver
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Search Results: trailer wiring
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer tires and wheels
- Video: Curt Mounting Bracket for 4-Pole Flat Trailer Connector Review
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer jack
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
- Shop: Brake Controller
on Trailer Tie Down Anchors
