What Hardware Should Be Used to Install a CE Smith V-Wing Bolster Bracket
Updated 03/08/2021 | Published 03/03/2021
Question:
What do I use to mount the v wing bracket to the steel 2x2 frame?
asked by: Davida M
Expert Reply:
In order to mount the CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers # CE26244G you'll want to use use lag screws and a washer to attach the brackets; these aren't part of any hardware that comes with the brackets so you'll need to source them via your local hardware store. According to CE Smith they recommend that a bracket be installed at each frame cross member for maximum support. The brackets are best when installed with a 2x6 or 2x8 carpeted bunk boards laid flat.
Product Page this Question was Asked From
CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers - Galvanized Steel - Qty 1
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- 6 Inch Tall
- 3 Inch Wide
- Galvanized Steel
- 15-1/2 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: How To Know Which Master Cylinder Will Be The Correct Replacement For A Surge Actuator
- Q&A: How To Install Rollers On a Pontoon Boat
- Q&A: How Many Screws Are Included With The Stainless Steel Hex Lag Screw # FA74521?
- Q&A: Would 7-Way Trailer Wiring Circuit Have Amperage Rating for Powering 13 amp Horn
- Q&A: Are All 3,500 lb Axle Hub/Drums Interchangeable
- Q&A: Solution for Transporting Native Titan 10.5 Kayak
- Q&A: How To Replace 18 Foot Long Bunk Boards On a Pontoon Boat Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: What To Look For When Buying Ratchet Straps