What Parts are Needed to Install LED Trailer Light # STL22RB
Updated 02/21/2013 | Published 02/13/2013 >
Products Featured in This Question
Question:
I want to replace the stock lights on my enclosed box trailer I have for my Lawn Care Equipment. I feel light these will work. By the picture they look the same as what I have. Question is, What all do I have to buy with these lights so as soon as they are delivered to me I can put them on and have them operating? Do I have to buy wiring connectors / ends they go onto these to convert from what I have now. I am ready to order but I want to order everything at one time for a turn eye switch over. Thanks for your advice.
asked by: Sanford G
Expert Reply:
First you are going to want to make sure that light # STL22RB is going to fit in place of the lights you have now. This light is 6-1/2 inches long and 2-5/16 inches top to bottom. If you require a different size let me know and I can determine what we have. There also may be a number on the light housing (not the lens) that will help identify what you have.
If this light will fit then you will need a wiring harness # A47PB for each light. It will plug into the back of the light and you will splice the blunt cut ends to your existing trailer wiring. The red wire will be wired to the turn signal circuit and the black wire will wired to the tail light circuit. The third (white) wire from the pig tail is the ground wire and will need to be attached to a good clean ground on your trailer.
If you damage a grommet when you remove the old lights you can use # a70gb as a replacement.
Product Page this Question was Asked From
Miro-Flex LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-5/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Video: Let’s Check Out the Buyers Products Recessed Chain Tie-Down for Trailers
- Search Results: safety chain
- Shop: Buyers Products Recessed Chain Tie-Down for Trailers - Carbon Steel - 6,600 lbs
- Q&A: Replacement Torsion Arm Kit w/a 5 on 4-1/2" Lug Nut Pattern for a 3,700 lbs Dexter Versa-Flex
- Article: Trailer Wiring Diagrams
- Q&A: Will The Optronics Flexible LED Light Strip UCL90CB Stick Under A Trailer/Camper?
- Q&A: Replacement for TDE LP85 Surge Brake Actuator
- Article: Trailer Lighting Requirements
- Q&A: Recommended Replacement for a 45 amp Progressive Dynamics 9200 Inteli-Power Converter PD9245C
- Q&A: Need Replacement Twist Lock Power Inlet For Coachmen Freedom Express 192rbs
- Q&A: Replacement Tail Light for Utility Trailer With Command Electronics 003-5400
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Installing Trailer Brake Controller on 2014 Chevy 4500 Chassis
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Sidewinder with Rotating Turret for Short Bed Pickups


Sandy G.
2/17/2013
I just notice they make a LED 48 Diode light also. Will it work and fit on my trailer light the 12 Diode would. Thanks for your help.