What Size Hole Should be Drilled to Install a 4 inch Optronics Clearance Light
Updated 02/14/2013 | Published 02/11/2013
Products Featured in This Question
Question:
I am installing these as a upgrade on my jeep. What size hole do i need to make in my jeep for these to fit into? Thanks
asked by: Philip P
0
Expert Reply:
You would want to drill a 4-1/2 inch hole to install the 4-inch Optronics Trailer Light # STL45RB.
You will also need a Straight 3-Wire Pigtail # A45PB to wire in the # STL45RB.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diodes - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Tie-Downs for 2026 Ford F-350 Long Bed With Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Lights for 1989 Interstate Box Trailer
- Article: Trailer Lighting Requirements
- Q&A: Replacement Trailer Tail Light For Bargman 47-54-001 LED Tail Lights
- Q&A: Recommended 3-Prong 3-Wire Pigtail for a Optronics Trailer Tail Light
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Solution for Replacement Side Marker Light for Glo Brite 9823R-88
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Pintle-Hitches
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: How to Measure Your Trailer Wheel Bolt Pattern