What Are Dimension of the 7/16-Inch Pin Used in Part # SL716SS?
Updated 02/07/2013 | Published 02/06/2013
Question:
Picture with dimensions would be greatly appreciated.
asked by: Chris
1
Helpful Expert Reply:
The Redline Spring Latch, part # SL716SS, uses a 7/16-inch sliding pin that is 6-3/4 inches long, with a handle end that measures 1-7/8 inches. The attached photo provides these and other measurements.
The pin and spring are stainless steel; the base is aluminum. Please note that mounting hardware is not included with this part.
expert reply by:
Adam R
1
click to enlarge
Product Page this Question was Asked From
Bolt-On Stainless Steel Spring Latch
- Trailer Door Latch
- Reversible
- Spring Latch
- Non-Locking
- Bolt-On
- Stainless Steel
- Redline
more information >
Continue Researching
- Q&A: Setting the Power Output and Boost Settings on a Tekonsha P3 Trailer Brake Controller
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: How Tight Should Shackle Bolts Be Tightened On Trailer
- Q&A: Replacement For A Dexter 8-249 Hub And Drum Assembly
- Q&A: Replacement Trailer Hub Seal for TCM 12194TC
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Idler Hub for 3,500 lb Big Tex Trailer Axle with 5 on 5" Bolt Pattern
- Q&A: Availability Of Replacement Brushes For CargoSmart Boot Cleaning Brush 3481733
- Q&A: Suspension Enhancement for Lowered 2007 Toyota Tacoma
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Lighting Requirements
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps