Dimensions of BDW20120 Bulldog Replacement Winch Clevis Hook
Updated 02/18/2021 | Published 02/15/2021
Question:
BDW20120. Hi there. For this part if the Clevis pin is removed what is the measured distance from the inner side of the “left” eye to the inner side of the “right” eye? Looks like about 2/3 inch, but if you could measure it with a micrometer I would sure appreciate it. Thanks
asked by: Dave
Helpful Expert Reply:
The diameter of the pin itself is 7/16 of an inch. The inside width of the opening where the cable attaches is 13/16 of an inch and the outside width of the hook on the end where the cable attaches is 1-5/16 inches.
You can see these dimensions in the attached photo of the # BDW20120 I created for you.
(click to enlarge)
Product Page this Question was Asked From
Replacement 5/16" Clevis Hook for 9/32" Winch Cable - 17,200 lbs
- Accessories and Parts
- Electric Winch
- Hooks
- 5/16 Inch Diameter
- Hook w Clasp
- Bulldog Winch
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Brakes for an AL-KO Axle. Can I Use Heavier Brakes?
- Q&A: Fifth Wheel Solution for Cab and Chassis Truck
- Q&A: Replacement Bearing Solution for DICO Hub 45263
- Q&A: Replacement Equalizers for Dexter 13-143 Equalizers
- Q&A: Best Brake Controller Recommendation for Electric Over Hydraulic Trailer Brakes
- Q&A: Replacement Grease Seal for my 3500 lb. Axles with Number 408004-8 on it
- Article: Dealer Spotlight - Taps Truck and Auto Accessories
- Q&A: Cleaning and Lubricating Recommendation for Roadmaster Tow Bars