On GP-PWM-30, The Float Voltage is Automatically Set Based on Battery Type
Updated 02/09/2021 | Published 02/04/2021
Question:
I have a GP-PWM-30 in my motorhome. I am about to install new AGM batteries in same. Is there a way to manually change the float voltage or is a set number when I choose AGM in setup?
asked by: James M
Helpful Expert Reply:
According to the User's Guide for the GP-PWM-30 Solor Charge Controller, you can specify the type of battery that you have, for instance AGM, but there is not a manual setting for the float charge level for any battery type. This unit features automatic multistage charging that switches modes as the battery charges. This helps extend battery life. It has preset charging profiles for sealed/gel, AGM, flooded, and lithium batteries.
I have attahced the User's Guide for your review.
Product Page this Question was Asked From
Go Power PWM Solar Charge Controller with Bluetooth - LCD Digital Display - Dual Bank - 30 Amp - 12V
- Solar Charge Controllers
- PWM
- 30 Amp
- Digital Display
- Gel
- AGM
- Flooded
- Lithium (liFePO4)
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Power a Furrion Camera System w/ a 2024 Chevrolet Silverado 3500
- Q&A: Troubleshooting Furrion Vision S+ Monitor Not Displaying Camera
- Q&A: Availability of Dometic 38362 Furnace
- Q&A: Lippert Hydraulic Level Up Generation II Jacks For Towable RV Campers
- Q&A: Wiring An Atwood RV Water Heater With Double-Panel On/Off Switch
- Q&A: Availability of Kenda ST235/75R15 Radial Off-Road Trailer Tire
- Q&A: Best Lithium Compatible Converter To Replace Magnetek 6332
- Article: Performance Chips and Modules
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Common Myths About RV Solar Power
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)