Keel Roller Option that Can Fit with Transom Brace
Updated 01/28/2021 | Published 01/26/2021
Question:
Hello. Do you have any recommendations on a keel roller that i can attach to my trailer so that i can use a transom brace? right now i have a 4hp outboard motor but im looking at upgrading to an 8hp motor
asked by: Darren
0
Expert Reply:
If you installed a keel roller that uses a U-bolt setup on the front of the trailer frame channel you could install the transom brace on the back side. Similar to the picture attached but on the last frame member which the roller in the picture is the # CE10455G.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
CE Smith Deep V Keel Roller Assembly for Boat Trailers - Galvanized Steel and Yellow TPR - 12"
- Boat Trailer Parts
- Rollers
- Keel Roller
- Plastic
- 12 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: How to Lower a Boat on a Bunk Trailer for Easier Launching?
- Q&A: Keel Roller Solution for Tracker 14 Grizzly to Help Center Boat
- Q&A: Looking for 9" Wide Rollers and Brackets for a Holsclaw Boat Trailer
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: How Does the CE Smith Single Axle Trailer Fender Attach to the Trailer?
- Q&A: Parts Needed to Install the CE Smith Single Axle Trailer Fenders w/ Top and Side Steps
- Q&A: How Wide Are Frame Clamps On CE Smith Post-Style Guide-Ons for Boat Trailers
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Spring Towing Readiness Checklist
- Article: Boat Trailer Guides: Which are the Best?
- Article: Where to Position the Trailer Axle?