Attaching the Lock N Roll Articulating Coupler to Tongue of Trailer where Bolt Holes Don't Line Up

Updated 01/20/2021 | Published 01/17/2021

Question:

Question. So I need some suggestions. I want to switch my trailer to the Lock-N-Roll. I have both parts, however, the trailer side part is the 2 channel trailer side. 336TS528 so here is the issue, my trailer existing trailer side ball recieve is on a 2 wide by 3 Tall trailer tounge. It is almost like I need a bridge a piece of metal with the inner dimensions of 2 wide and 3 tall wide and bolt holes to join the two pieces Almost like a splint to link two butt joins.

asked by: Dirk L

Expert Reply:

One easy solution would be to have the Lock N Roll # 336TS528 welded to your 2 inch wide trailer tongue if the bolt holes don't line up. This is the most common way to install couplers as lining up bolt holes isn't always possible.

expert reply by: Jameson C