What is the Diameter of the Washer on the Pull Pin End of the Clevis Pin?
Updated 01/05/2021 | Published 12/31/2020
Question:
I need a 1” pin for a log splitter-what is the outside diameter of the washer on the pull ring end?
asked by: Mark B
1
Helpful Expert Reply:
The diameter of the washer on the pull-ring end of the Brophy # CP20 Clevis Pin is 2 inches.
expert reply by:
Les D
1
Product Page this Question was Asked From
Brophy Clevis Pin for 2" Clevis Mount - Zinc Plated - 6-1/8" Long x 1" Diameter
- Hitch Pins and Clips
- Clevis Pin
- 4-1/8 Inch Long
- 1 Inch Diameter
- 4-1/8 Inch Span
- Brophy
more information >
Continue Researching
- Q&A: How To Install The Plug-And-Play Hydrastar Vented Marine Electric Over Hydraulic Actuator
- Q&A: Best Replacement Options for TDE LP8000 Surge Brake Actuator (3" Tongue, 8K Trailer)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Actuator for Tie Down TDE LP8000
- Q&A: Replacement Power Unit for Bulldog Winch BDW15019
- Q&A: Can Hydraulic Surge Brake Actuator be Locked Out for Electric Brake Conversion
- Q&A: Locking Out Dexter Surge Actuator to Convert to Electric Over Hydraulic
- Q&A: Parts Needed to Convert a Surge Disc Brake Trailer to an Electric Over Hydraulic Setup