What Do Keel Rollers Fit Onto on Boat Trailer
Updated 01/01/2021 | Published 12/30/2020
Products Featured in This Question
Question:
Are these even a bolts? I need a replacement for my roller shown on the picture. Seems similar. Not sure about the bolts. How long are the bolts used for the # CE10403G roller?
asked by: Marat B
0
Expert Reply:
Keel rollers like the part # CE10403G that you referenced fit on a shaft that has pal nuts on either end of it. The part # CE10705A is an example of a shaft with the pal nuts. This is a shaft that is 12-3/4 inches long and 1/2 inch in diameter. Pal nuts basically are a friction fit that get tapped onto the end of the shaft.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Deep V Keel Roller Assembly for Boat Trailers - Galvanized Steel/Black Rubber - 8"
- Boat Trailer Parts
- Rollers
- Keel Roller
- Rubber
- 8 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: What Size Lag Bolts do I Need to Swap Out Bunk Boards on 20 Foot Bass Boat?
- Q&A: Can the Yakima Holdup # Y02433 Be used with Bikes that Have Fenders
- Q&A: How Long of Lag Bolts Should I Use w/ the CE Smith Bolster and Swivel Bracket Assemblies?
- Q&A: Recommended Roller Bunks Replacement for Wooden Bunks for G3 1860 Boat
- Q&A: Can Bunk Boards Longer Than 69-1/2" be Installed on a Boat Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Solution to Re-Wire 4 Way Trailer Plug with 8 Wires
- Q&A: Recommended Keel Roller For Best Weight Capacity on Boat Trailer
- Article: Trailer Lighting Requirements
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle