Can I Fit the Pop and Lock # PAL9000 on an UnderCover Elite LX Hard Tonneau Cover
Updated 12/15/2020 | Published 12/11/2020
Question:
How can I tell if my tonneau cover handle is 1 1/4inch or less - what do I measure?
asked by: Terry G
Expert Reply:
The 1-1/4" or less you're referring to for the Pop And Lock # PAL9000 refers to the hole size that is left when your handle is removed, which you should be able to get an idea of by looking on the back/inside of the tonneau. However, I spoke with my tech contact over at Pop and Lock and he mentioned that ideally the handle is 1-1/8" and that a 1-1/4" handle might be too tight of a fit. Additionally, you'll want to make sure that your handle connects to cables and not rods, to allow for opening of the tonneau, since no Pop and Lock products are compatible with rod actuators.
As long as your Undercover Elite LX tonneau cover meets those two requirements then you can use the # PAL9000.
Product Page this Question was Asked From
Pop & Lock Power Pop Remote Keyless Entry Kit for Hard Tonneau Covers
- Accessories and Parts
- Tonneau Cover
- Locks
- Pop and Lock
more information >
Continue Researching
- Q&A: Pop & Lock Keyless Entry Entry For UnderCover Tonneau Cover
- Q&A: Replacement Load-N-Lock Power Lock for Hard Tonneau Covers and Truck Caps
- Q&A: Replacement Remote Receiver for Retrax Powered Retractable Tonneau Covers
- Q&A: Pop & Lock Power Lock Conversion Kit for A.R.E. LSII Tonneau Cover
- Q&A: Troubleshooting Surge Brake Boat Trailer that Makes Slamming Sound When Hitting Bumps
- Q&A: How Many Hub Savers Do I Need and Where Do They Install?
- Q&A: Installation Of Pop & Lock Manual Lock For 1998 Ford Ranger Tailgate
- Article: 7 Common Questions Everyone Has About Trailer Tires