Wiring in a Camper Shell 3rd Brake Light on a 2006 Chevy Silverado 1500.
Updated 01/04/2013 | Published 01/03/2013
Question:
How do I install a third brake light for a camper top/shell for a 2006 Chevy Silverado 1500 4x4 Crew Cab. Where is the wire.
asked by: Carlos
0
Expert Reply:
The main trailer wiring harness is located under the truck bed, usually above the spare tire. There is usually a socket for your trailer connector to plug into, but if you peel back the wire loom you will find a light blue wire further up in the wiring harness that is intended for use for a third brake lamp on a camper shell.
I attached a couple pics to help you see where the wire is at.
expert reply by:
Jameson C
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: 1999-2006 Chevy Silverado Third Brake Light Wiring Source for Camper Shell
- Q&A: 2-1/2" Hitch Receiver Extension that Reduces to 2" Receiver
- Article: Trailer Wiring Diagrams
- Q&A: Can Oil Cap RG04-230 be Used as Grease Cap
- Q&A: Way To Protect 7-Way Pins When The Door/Flap Has Broken Off
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Do You Know the Difference Between a 11033 Hub and My 11033L Hub?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Flat Towing Parts for a 2026 GMC Sierra 1500
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne