What are the Dimensions of the Combo Bar 6 inch
Published 08/04/2009 >
Question:
What are the outside dimensions of the square tube excluding the collar on the end?
asked by: Todd A
0
Expert Reply:
The overall width of the Combo Bar 6 inch with 1-1/4 inch Trailer Hitch Receiver, part number E-911, is 1-5/8 inches. Other dimensions of note are 4 inches from center of hitch pin hole to back of the bar, 2 inches from center of the hitch pin hole to the front of the collar and the overall length is 6 inches.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Combo Bar 6" with 1-1/4" Trailer Hitch Receiver
- Hitch Fabrication Parts
- Receiver Tube
- 6 Inch Long
- Raw Finish
- Fits 1-1/4 Inch Hitch
- 1/2 Inch Thick
- CURT
more information >
Continue Researching
- Q&A: Lug Nuts And Center Caps For The Aluminum HWT Hi-Spec Series 03 Mod Trailer Wheels
- Q&A: Securing Aluminum Wheels Correctly on Camper with 1/2 Inch Lugs
- Q&A: Can I Replace 8-14.5 Tires with a Non-Metric Sized Tire
- Q&A: Degree of Tolerance for Curt Trailer Hitches
- Q&A: Replacement Trailer Tail Light for a DOT SAE A216S2T2L 18
- Q&A: Hub & Drum With Electric Brakes Replacement For AL-KO 8700 Hub
- Q&A: Replacement Tail Light Lens for SAE 2AS2T216
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Where to Position the Trailer Axle?
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Performance Chips and Modules

