Trailer Hitch Recommendation for the Step Bumper on a 2010 Ford Ranger
Updated 11/30/2012 | Published 11/26/2012
Question:
What hitch will fit on my 2010 ford ranger step bumper?
asked by: Bill
Expert Reply:
If the bumper itself has a hole for a ball then you could just use the bumper to tow. Consult the owners manual for the capacity (usually up to 3,500 pounds on many applications, the owners manual should have the correct information). If you need to add a receiver then a hitch like # E-3S is going to be the best option. Take a look at the picture I have included to see the mounting hole dimensions. I have also linked the instructions for you. I have also included a link to the frame mount trailer hitches for the 2010 Ford Ranger.
Product Page this Question was Asked From
Curt 2" Trailer Hitch - Bumper Mount - 8-3/4" Bolt Pattern - 5,000 lbs GTW
- Bumper Hitch
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Front Hitch Recommendation for Bike Rack for 2004 Fleetwood Tioga
- Q&A: Recommended TorkLift Hitch and Extension for a 2025 GMC Sierra 2500 w/a Camper Pulling a Trailer
- Q&A: Can Dylux Tankless RV Water Heater Be Used In Winter? Does It Have Freeze Protection?
- Q&A: Front Mount Hitch for 2000 Ford E-450
- Q&A: Does Front Plastic Valance Get Removed to Install Curt Front Hitch # 33055
- Q&A: How to Determine the Correct Replacement Wiper Seal for a 2017 Keystone Bullet 243BHS
- Article: Trailer Wiring Diagrams
- Q&A: RV AC Unit Recommendation for 14 inch Roof Opening that Doesn't Require Wall Thermostat
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch