Can The Wave 3 Heater Be Recess Mounted On A Wall

Question

Question:

Can the wave 3 heater be recessed partially into a wall like the model 6?

asked by: Gary P

1

Helpful Expert Reply:

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs Item # CAM57331 is designed to be wall mounted due to the size of the unit.

expert reply by: Shane H

1

Answer 1

We have just what you need, the Go Power Portable Solar Panel with Digital Solar Controller, #34282610. This lets you place the solar panel where you need it for maximum sunlight while not having to place the camper in the sun too. For the later…

view full answer...

Answer 2

Actually to install the Prodigy P3 Brake Controller part #90195 in your 2007 Chevy Tahoe you don't need an install adapter. There are 4 blunt cut wires under the dash that will allow you to wire the controller directly to your vehicle. GM did not…

view full answer...

Answer 3

The Tekonsha Prodigy P3 Brake Controller, #90195, does not have an on and off switch. It will go into sleep mode after several minutes of no activity. The power draw when it is in the sleep mode is so negligible that it will not discharge the…

view full answer...

Answer 4

I reached out to my contact at Camco regarding the Olympian Wave 3 Catalytic Safety Heater #CAM57331 and he said the heater requires at least 4" of clearance on each side and at least 30" of clearance from the front of the unit (where the…

view full answer...

Answer 5

The distance between the left and right mounting holes on the back of the Camco Wave 6 heater, part #CAM673541 is 9.65 inches.

view full answer...

Answer 6

I checked with Camco, and the clearances are the same; you will need 4 inches of clearance on the sides, 18 inches of clearance on top, and 30 inches of clearance in the front for the Camco Olympian Wave 6 Catalytic Safety Heater for Mid-Sized RVs…

view full answer...

Answer 7

For the Camco Olympian Wave 6 Catalytic Safety Heater #CAM57341, a low-pressure regulator is designated as 11" w.c. (water column), as you can see in the accompanying cut outs I added. You can go from a hose to the furnace with the Camco…

view full answer...

Answer 8

I took a look at the online version of the owner's manual for your 2014 Cadillac Escalade and found that it features a towing capacity of either 8,300 pounds for the 2WD model or 8,100 pounds for the AWD model. I do still recommend verifying this…

view full answer...

Answer 9

If you will be permanently installing the Camco Olympian Wave 3 Catalytic Safety Heater part #CAM57331 then you would need to run a hose from the heater to the propane manifold. I cannot recommend you tap or splice into an existing line. The fitting…

view full answer...

Answer 10

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs #CAM57331 can heat a larger area (120 square feet) compared to the Little Buddy Heater which claims 95 square feet, has a built in automatic Piezo-electric spark starter which will last…

view full answer...

Answer 11

Yes. The Camco Olympian Wave Heater #CAM57331 can be used as your primary source of heat and can be setup to be both permanently installed or portable. This is a heating solution that is safe to sleep with the unit on, but you will need to leave a…

view full answer...

Answer 12

To connect your Camco Olympian Wave 6 #CAM57341 to your propane tank you will want the Camco Low-Pressure LP Gas Regulator #CAM57703. This comes with a 6 foot hose and is rated for 75,000 BTUs per hour.

view full answer...

Can The Wave 3 Heater Be Recess Mounted On A Wall

Product Page this Question was Asked From

Continue Researching