Measurement Between Two Mounting Holes On Short Side Of Bracket
Updated 10/08/2020 | Published 10/06/2020
Question:
What is the measurement between the two holes in inches? on the short side of L. 2 inch?
asked by: Julian
1
Helpful Expert Reply:
The measurement between the two hole on short side of Angled Up Mounting Brackets for Rhino-Rack Sunseeker Awning - RSP, RS 2500, and SG Roof Racks Item # RR32123 is going to be 2" center on center.
expert reply by:
Shane H
1
click to enlarge
Product Page this Question was Asked From
Angled Up Mounting Brackets for Rhino-Rack Sunseeker Awning - RSP, RS 2500, and SG Roof Racks
- Accessories and Parts
- Car Awning
- Mounting Hardware
- Brackets
- Sunseeker
- Rhino Rack
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Q&A: Distance Between The Mounting Tabs On A The Roadmaster Direct-Connect Base Plate Kit # 1437-3
- Q&A: Dimensions and Hole Spacing for Roadmaster MS Base Plate Kit - Fixed Arms Item # 1437-3
- Q&A: Roof Rack Recommendation to Fit Cargo Box and Awning on a 2022 Subaru Forester Wilderness
- Q&A: Can Oil Bath Trailer Hub Easily be Converted to Grease
- Q&A: Is there an Adapter to Fit a Hitch Ball with 1 Inch Diameter Shank in a 1-1/4 Ball Hole
- Article: How to Measure for Motorhome Steps
- Article: How to Install an RV Awning From Scratch