Dexter Trailer Springs Over-Under Conversion Kit Recommendation for Additional Ground Clearance
Updated 11/13/2012 | Published 11/11/2012 >
Question:
my trailer really sits low sometimes backing in on incline back bumper nearly bottoms out wondering if i can raise it
asked by: Bob P
Expert Reply:
Yes, you can use a Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00 like you referenced to gain a little ground clearance. This product will allow you to move the axles of your trailer from above the leaf springs to below the leaf springs which will give you additional ground clearance.
As long as you have a 3 inch round axle this product would work well for you. 3 inch axles are primarily used on 6,000 lb and 7,200 lb axles.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Shop: Replacement U-Bolt w/Nuts for 8,000-lb, Round Trailer Axles - 9/16" Diameter
- Search Results: 117581
- Search Results: trss350
- Q&A: Recommended Gooseneck Trailer Adjustment for Towing with a Ford F-250 with 4 Inch Lift
- Shop: U-Bolt Plate for 3-1/2" Diameter, Round Trailer Axles with 1-3/4" or 2" Wide Springs
- Shop: Spring Seat for Typical 8,000-lb, Round Trailer Axles with 3-1/2" Diameter
- Video: TruRyde Trailer Suspension TRSS350 Review
- Video: Redline Trailer Suspension 117581 Review
- Search Results: lift blocks
- Video: Complete Breakdown of the Dexter Trailer Springs Over-Under Conversion Kit
- Video: Hands-On with the Dexter Trailer Springs Over-Under Conversion Kit
- Q&A: Availability of 3-1/2 Diameter Axle U-Bolt
- Q&A: How to Raise a Trailer for More Ground Clearance
- Q&A: How To Lift Trailer with 3-1/2 Diameter 8k Axle With Center Point Suspension Already Installed
- Shop: Correct Track Trailer Alignment and Lift Kit - Tandem Axle
- Q&A: Best Ways To Raise a Trailer for More Tire Clearance
- Q&A: Hardware for Over-Under Conversion on 3-1/2 Inch Axle
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Q&A: Will The Dexter Springs Over Under Conversion Kits Work With Lippert Axles?


