Lippert PSX1 RV Stabilizer Motors Not Working When Installed on RV
Updated 08/27/2020 | Published 08/25/2020
Question:
Both electric lippert ps1x stabilizers on our 2018 Coleman 2835BH went out at the same time. Ive tested for voltage through the switches and all the way to the motors. The continuity and voltage are there. It would be quite the coincidence for both motors to quit at the same time. So I pulled one motor off and hooked straight up to a 12V battery and it operated fine. I cant find a wiring diagram of the circuit or for the trailer anywhere. Any ideas? Thanks for your time.
asked by: Joe H
Expert Reply:
I spoke with the folks at Lippert who tell me that your issue sounds like a ground problem. The fact that you can get the motors to operate independently of the coach by directly attaching them to a battery would tend to confirm a poor ground connection. I've provided a wiring diagram for the Lippert PSX1 stabilizer.
Product Page this Question was Asked From
Replacement 6-Amp Auto Reset Breaker for Lippert Power Stabilizer Jack
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Breaker
- Lippert
more information >
Continue Researching
- Q&A: Fuse and Breaker Locations on Lippert Power Stabilizer Jack for Forest River Trailer
- Q&A: Troubleshooting Lippert Electric Stabilizer Jack Not Working
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: Does the Curt Helux Pin Box Work w/ a Anderson Ultimate 5th Wheel Hitch?
- Q&A: Looking for Wheel Center Cap AC-375TT
- Q&A: Wiring Diagram for Lippert Stabilization Jack LC298707
- Q&A: What is the Correct Cold Tire Pressure for a ST215/75R14 Trailer Tire
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: How to Replace or Install an RV Roof Vent
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)