Why Would Furrion Vision S Side Cameras Light Up But No Camera Power On

Updated 09/30/2024 | Published 08/08/2020

Question:

We purchased the Furrion Vision S rear observation and side camera system. The rear camera is working without any trouble, but when we have been unable to get the side cameras to pair with the monitor. The side lights are working, but the blue light on the camera is not lit up on either side. We have triple-checked the wiring, tried manually pairing, and still no luck. Can you help?

asked by: Alison M

Expert Reply:

The side cameras of the Furrion Vision S systems have three wires that run to them. A ground, a light power circuit, and a camera power wire circuit. My guess is the camera wiring has not been complete and that's why they aren't powering on. See attached picture.

expert reply by: Jameson C

click to enlarge

Dan B.

9/27/2024

Side light comes on. No signal on screen from the driver side. Do have power on brown and red wires? What's up. Issue inside camera itself?

Jameson C.

9/29/2024

@DanB Are you sure it's grounded properly?

Dan B.

9/30/2024

@JamesonC it's only the drivers side that is affected. It is a 21 Solitude. It has worked fine until our last trip home from Fla. to Mn.. None of the other lights or cameras are affected! If it was the ground wouldn't the light it is connected to also be affected?

Jameson C.

9/30/2024

@DanB Yes that is a good point the light wouldn't work either since it is grounded on same circuit but you might still just check that as well as connections at the fixture and further up. It does sound like it is wired properly and it is just damaged and no longer working but sometimes its just as simple as checking the wiring and grounds. Basically its either the wiring or the camera itself is broken.