Troubleshooting RVS-062710 Cameras That Blink With Turn Signals On
Updated 07/30/2020 | Published 07/28/2020
Question:
Wired to front blinkers , but when engage blinker the picture blinks with the light . Do I have to wire in a time delay? If so which one ?
asked by: Glynn B
0
Expert Reply:
If the cameras are turning on and off as the turn signals blink, it indicates that you've connected to the incorrect power wire. Instead of the turn signal wire, use the running lamp circuit as the power wire. To turn on the camera, you'd just turn on the RV running lamps which would power up the cameras.
I've linked to the installation instructions plus a product demonstration video.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Rear View Safety Backup Camera System - 4 Camera Setup - Quad View Monitor
- RV Camera System
- Backup Camera
- Mirrored Image
- Night Vision
- Removable Sunshade
- Hardwired
- Wide View
- Dashboard Mounting Bracket
- Suction Cup Mount
- Rear
- 7 Inch Display
- 4 Cameras
- Rear View Safety
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement for a Perimeter View Camera System
- Q&A: Troubleshooting An RVS RV Camera That Stopped Working
- Q&A: What Propane Gas will Replace My CCI Controls Model No. 7719 LP Gas Leak Detector?
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Dexter 10,000LB Axle Wheel Retaining Ring Placement
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Best Option For Replacing Damaged Monitor On Triple Vision M-70 Camera System
- Q&A: Can I Install The Demco Autoslide 5th Wheel Hitch DM8550038 With A Liner In The Bed?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Performance Chips and Modules
- Article: Converting Your RV Water Heater to Tankless
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Determining Trailer Tongue Weight