Will the Motor and Switch Kit for Stromberg Carlson Landing Gear Fit Atwood
Updated 07/15/2020 | Published 07/13/2020
Question:
I was told this kit will fit the Atwood landing gear system is this true? I measured the bolt holes on mine they are the 4 1/8 center same as this.
asked by: Ted L
0
Expert Reply:
It is very possible that the Motor and Switch Kit for Stromberg Carlson Landing Gear part # LG-217884 could fit Atwood Landing Gear Legs as most of these landing gear parts are interchangeable among brands.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement for Atwood Landing Gear Motor 75391
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: Landing Gear Switch Installation and Wiring Diagram
- Q&A: Landing Gear Motor Replacement for 065-041012-01 with 7140 RPM
- Q&A: Replacment Landing Gear Leg for Atwood Landing Gear
- Q&A: Powered Landing Gear Motor Recommendation for 20K-lb 5th Wheel Trailer
- Article: Best Landing Gear
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Converting Your RV Water Heater to Tankless
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers