Recommended Trailer Hitch for my Geo Pro Camper

Question

Question:

You recommend the hitch with a 18 to 51 inch length. My geo pro has a measurement outside rail to rail of 59 inches. What hitch do you recommend?

asked by: Ricky O

0

Expert Reply:

For your Geo Pro Camper with a 59" frame rails width the DrawTite Multi-Fit Motor Home Trailer Hitch part # 82201 is an excellent choice. I like the really low profile it offers allowing it to fit snugly up under the camper. It mounts with the provided hardware directly to the frame of the camper and allows you to position it where you want it as far as more inboard or more outboard depending on where you want the receiver tube opening.

The instructions are linked below if you'd like to check it out!

expert reply by: Randy B

0

Answer 1

To use the Pro Series RB3 on two trailers would only require you to get a second set of spring hangers. For that you would want the part #RP6637 and for the chains part #55630.

view full answer...

Answer 2

To choose a weight distribution system you will need to go by the total tongue weight of the set up. This is calculated by taking the tongue weight of the trailer, when loaded and ready to tow, and adding to that the weight of anything loaded behind…

view full answer...

Answer 3

You would definitely want to go with the higher tongue weight range Strait Line system part #RP66084. The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow.…

view full answer...

Answer 4

If you are planning on towing with your 2000 Volvo V70, you will not want to exceed the towing weight capacity or tongue weight capacity listed in your owner's manual. Doing so can cause damage to the vehicle, along with creating an unsafe…

view full answer...

Answer 5

The best option I have to install a trailer hitch on the back of a Forest River Geo Pro to be used for carrying a motorcycle is the Curt Adjustable Trailer Hitch Receiver part #C13701. The Curt hitch features a four bolt installation so it will be…

view full answer...

Answer 6

For your 2020 Forest River Geo Pro I recommend using the Adjustable Width Trailer Hitch Receiver #13703, this will fit most trailer frames; spanning from 22" to 72". This hitch will use the bolt holes on the frame of your trailer to mount,…

view full answer...

Answer 7

The Swagman Spire Fork Adapter #S64706 will accept an axle up to 100mm in length. If you have a 110mm length axle then you also need the Spire Fork Adapter #S64708 to accommodate the longer axle. Please note that this is meant to be used on bike…

view full answer...

Answer 8

For your Swagman Truck Bed Bike Carrier #S64702 you can use Replacement Fork Mount #SP484. The other part you referenced #S62FR looks similar but is intended as a free-standing bolt-on carrier that is designed to be used on its own.

view full answer...

Answer 9

You'd choose the correct weight distribution/sway control system based on the fully loaded and ready to tow tongue weight of your 2022 Rockwood GeoPro which would range from about 450 to 650 lbs. I'll link to a help article that explains how…

view full answer...

Answer 10

The trailer coupler on your Forest River Rockwood Geo Pro G19FD is a top mount otherwise known as an overslung coupler. With that being said, due to the limited amount of space you have on your tongue, I really don't think the Fastway e2 Weight…

view full answer...

Answer 11

I recommend the Fastway e2 Weight Distribution System part #FA92-00-0600 with 2" Hitch Ball part #A-90 for a Forest River Rockwood Geo Pro 15TB. In regards to using a weight distribution system, the rule of 10-15% for tongue load will still…

view full answer...

Recommended Trailer Hitch for my Geo Pro Camper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching