Replacement Nut and Screw for a Bulldog 10K or 12K Capacity Landing Gear Trailer Jack
Updated 08/22/2012 | Published 08/19/2012
Products Featured in This Question
Question:
I have a Bulldog 4inch square leg side wind landing gear style jack. I believe its 10,000/12,000# rated. The nut at the top of the jack that the screw runs in is worn out. Its 4inch square and slides into the outer tube secured by 2, 1/2inch pins. It appears to be gray cast iron. Can this nut be purchased?
asked by: Brent H
Expert Reply:
The nut by itself is not available as a separate part but we do have the screw and nut assembly, # BD500250. It is designed just like you have said with the 2 roll pins and is rated for 10K lift and 12K static load.
We also have # BD500217. It is designed to fit Bulldog series 182 jacks from 2003 to present, with 12K capacity.
Product Page this Question was Asked From
Bulldog Square Jack - Fixed Leg - Sidewind - 12-1/2" Lift - 10,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Side-Mount Jacks
- Steel
- 9001 - 10000 lbs
- Manual Jack
- 12-1/2 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Video: Review of etrailer TJD-12000 Series Jack Replacement Rod And Nut - TJD-12000-RODNUT
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Search Results: trailer jack
- Shop: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Q&A: Replacement Jack Rod and Nut For 10k/12k Trailer Jack
- Video: Review of etrailer Camper Jacks - Trailer Jack - TJD-12000SP-FIP
- Shop: Replacement Square, Direct Weld Jack Inner Tube with Spring-Return Drop Leg
- Shop: Grease Seal 29031
- Search Results: bd500250
- Search Results: bd182815
- Video: Comprehensive Review: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Q&A: Replacement Inner Jack Tube With 3-1/2" X 3-1/2" Square Tube
- Q&A: Will The Replacement Inner Tube TJD-12000SP-FIP Fit A Bulldog Jack?
- Search Results: bd500217
- Video: Checking Out the Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Shop: Replacement Inner Tube with Drop Leg, Foot, and Pull Pin for Curt Heavy Duty Direct Weld Square Jack
- Q&A: Replacement Spring Loaded Jack For A Binkley 48000 SL
- Q&A: What is the Shortest 10,000 lbs Trailer Jack that Can Be Connected in Tandem?
- Q&A: What Size Pipe Mount Does the Bulldog Square Jack w/ Round Pipe Mount BD182524 Use
- Q&A: Recommended Drum to Disc Brake Kit for a 3500 lb Tandem Axle Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them