Ball Mount with at Least 3 Inches of Drop that is Longer Than 9-3/8 Inches Long for Old Rat Trike
Updated 08/17/2012 | Published 08/16/2012
Question:
I have an old rat trike so everything has to be custom,i need a ball mount that has a drop of at least 3 inches and the length needs to be longer that 9 3/8 from hole to hole. This one does not say it has to be in raise only Can this be used for drop also
asked by: Michael L
Expert Reply:
Ball mount # 36063 does have to be used in the rise position only. How about ball mount # 3592. It has a drop of 2-3/4 inches and measures 9-3/4 inches from the center of the hitch pin hole to the center of the ball hole. It is designed for Class I or II hitches. This is going to be the best option out of the ball mounts we carry.
Product Page this Question was Asked From
Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 11-3/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Rise - 3 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Draw-Tite
more information >
Continue Researching
- Q&A: Is There A 2-Ball Attachment That Fits The Lock N Roll 3-Position Adjustable Channel Bracket LR74VR
- Article: RV Pre-Departure Checklist
- Q&A: Why Can't Class II Accessories Be Used with Class I Trailer Hitch Receiver
- Q&A: Recommended Highest Rise Ball Mount for a 1-1/4" Hitch
- Q&A: Do Longer Hitch Extenders Reduce Hitch Capacity
- Q&A: Extended Ball Mount For Jeep Wrangler To Clear Oversized Spare Tire
- Article: Dexter Service Bulletin #014
- Article: Trailer Wiring Diagrams
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: How to Measure for Trailer Hitch Drop
- Q&A: 2025 Toyota Sienna Wiring Needed for the Tekonsha Prodigy RF Brake Controller
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Dielectric Grease Review