Correct Replacement Landing Gear Legs for a 2008 Keystone Raptor 5th Wheel
Updated 06/04/2020 | Published 06/02/2020
Question:
Hello. I needed a complete replacement landing gear legs for my keystone 08’ Keystone Raptor 3712TS. One was completely bent and the other has the foot torn off from Hurricane Harvey. I just bought it from my brother in law. Thank you
asked by: Ronny H
Expert Reply:
In order to find the correct set of landing gear legs for a trailer you need to measure the distance between the weld stops on the legs. The most common is 15-1/2" and likely what you have now and if that's the case you can use the Lippert Electric Landing Gear Set part # LC333964 as a direct replacement.
If you have a different measurement just let me know what that is.
Product Page this Question was Asked From
Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Determining if Replacement Landing Gear Set Will Mount to Existing Brackets on Trailer
- Q&A: Recommended Replacement Lead Leg for Bent Leg on Jayco 5th Wheel Trailer
- Q&A: Replacement Landing Gear for 2010 Open Range 5th-Wheel Trailer
- Q&A: Recommended Lock for MORryde GooseTech 5th Wheel to Gooseneck Pin Box
- Q&A: Recommendation to Replace Landing Gear on 2006 Keystone Raptor 3712 5th Wheel Trailer
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Motorhome Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps