Can 12 inch Electric Trailer Brake Assemblies be Replaced with Hydraulic Assemblies
Published 05/02/2020 >
Products Featured in This Question
Question:
can this hydraulic brake assemble be replaced with 12x2 electric brake assemblies
asked by: Thomas M
0
Expert Reply:
Yes, if you had a set of 12 by 2 inch electric trailer drum brakes you could replace them with the hydraulic drum brake kit part # 23-336-337 or vice versa. The Dexter electric set in the same size and 7k capacity is the part # 23-464-465.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Hydraulic Trailer Brakes - Duo Servo - 12" - Left/Right - 7K
- Trailer Brakes
- Hydraulic Drum Brakes
- Standard Grade
- Dual Servo
- Manual Adjust
- 12 x 2 Inch Drum
- 7000 lbs Axle
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Recommended Electric Over Hydraulic System for Keystone Montana High Country 5th Wheel Trailer
- Q&A: Brake Shoes for 12 x 2 Dexter Duo-Servo Hydraulic Brake Assemblies
- Q&A: Troubleshooting a Dexter DX Series Electric Over Hydraulic Brake Actuator Not Building Pressure
- Q&A: Estimated Install Time For Air Lift Loadlifter Air Helper Springs AL55FJ On 2020 Ford F-250
- Q&A: Replacement brake Assemblies For A 2015 Grand Design 337RLS
- Q&A: Can Oil Bath Hubs Seal and Cap Be Used with Grease
- Q&A: Will the Dexter 7,000 Lb Electric Braking Assemblies Fit a 5,200 Lb Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Measure a Trailer Axle

