Troubleshooting Hitch Bolts That Wont Thread Into Weld Nuts on 2012 Toyota Venza
Updated 04/29/2020 | Published 04/28/2020
Question:
The bolts received with hitch dont seem to fit the welded nuts on my 2012 Venza. I dont want to force them and cross thread. I tried the hardware store going down in size to a 8mm but it slips right through the nut. Suggestions?
asked by: Paul
Expert Reply:
If you haven't already, I would recommend taking a nylon brush and some spray lubricant like the LubriMatic # L11474 and clean out the weld nut holes on your Curt # C12341 hitch. There could be some built up rust, dirt or other debris that is clogging up the holes and keeping you from getting them into the holes-these should thread by hand at the start.
If you've already tried this step, please let me know and I can recommend some alternative steps.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Trailer Hitch and Accessories for Towing 5 x 8 Foot ATV Trailer with 2015 Toyota Venza
- Q&A: Recommended Hitch and Wiring Harness for 2015 Toyota Venza
- Q&A: How To Choose Correct Tire Load Range for Trailer with 3,500 Lb Axle
- Q&A: Deciding Between The Curt And Draw-Tite Hitches For My 2021 Subaru Forester
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 2016 Toyota Venza Trailer Hitch Recommendation for Carrying Bike Rack
- Q&A: Can Trailer Hitch be Installed on 2015 Toyota Venza With AWD All-Wheel Drive
- Q&A: Trailer Hitch Recommendation for 2012 Toyota Venza
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Best Bike Racks for Electric Bikes