What is the Width of the Opening of the Curt S-Hook
Updated 04/14/2020 | Published 04/11/2020
Question:
the holes in my jeep attachment are .675 diameter. the distane to the edge is about the same at .650 the quick links that came with my safety chains are too small to fit. i tried some larger quick links only to find that the opening was the same, only the shaft size larger maybe your locking s hooks will work how wide is the opening?
asked by: David B
0
Expert Reply:
The Curt S-Hook with Wire Keeper for Safety Chains and Cables part # C81830 has an opening that is 3/4". Based on your measurements this should workout for you.
expert reply by:
Randy B
0
Product Page this Question was Asked From
Curt S-Hook with Wire Keeper for Safety Chains and Cables - 17/32" - 7,600 lbs
- Accessories and Parts
- Safety Cables
- Tow Bar
- Trailer Safety Chains
- Safety Cable Parts
- Safety Chain Parts
- 17/32 Inch Diameter
- 7600 lbs GTW
- S-Hooks
- CURT
more information >
Continue Researching
- Q&A: What To Do When There Is No VIN On A Trailer
- Q&A: Replacement Thermostat for Dometic 3316410.012
- Q&A: Info Needed to Pick Out Trailer Axles for Airstream Safari 25SS
- Q&A: Which Grease Seal Will Fit a Dexter K71-305-00 For My Trailer Axle
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground
- Q&A: Install Instructions/Owners Manual of Demco Hijacker Autoslide Fifth Wheel 13k Fifth Wheel Hitch
- Q&A: Safety Chain Hook Replacement with a Larger Clevis Hook for a Class V Trailer Hitch
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes