Will the Curt Receiver E-3S Fit my 1978 Chevrolet Truck?
Updated 04/15/2020 | Published 04/06/2020 >
Question:
I have a 78 Chevy truck with a step bumper. the holes measures 8inch on center. I see the holes are 8- 3/4inch on center and oblong on the E3S. Will the E-3S fit my step bumper?
asked by: Gary T
Helpful Expert Reply:
Yes you will have the room that you need on the Curt 2" Trailer Hitch part # E-3S to move those the 3/8" closer in that the 8.75" center to center measurement.
The one issue you may run into would be the powder coat. If you need to you can remove a little bit of the material with a drill or file to get that extra little bit of clearance you need.
Product Page this Question was Asked From
Curt 2" Trailer Hitch - Bumper Mount - 8-3/4" Bolt Pattern - 5,000 lbs GTW
- Bumper Hitch
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Front Hitch Recommendation for Bike Rack for 2004 Fleetwood Tioga
- Q&A: Recommended TorkLift Hitch and Extension for a 2025 GMC Sierra 2500 w/a Camper Pulling a Trailer
- Q&A: Can Dylux Tankless RV Water Heater Be Used In Winter? Does It Have Freeze Protection?
- Q&A: Front Mount Hitch for 2000 Ford E-450
- Q&A: Does Front Plastic Valance Get Removed to Install Curt Front Hitch # 33055
- Q&A: How to Determine the Correct Replacement Wiper Seal for a 2017 Keystone Bullet 243BHS
- Q&A: How to Install Prodigy P3 Brake Controller 2024 Ford Maverick Hybrid
- Article: Trailer Wiring Diagrams
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight



Gary T.
4/14/2020
Thanks Randy for answering my question. I highly recommend etrailer for anything to do with hauling and trailers.