What Size Screw Does the Replacement Endcap for Westin Sure-Grip Running Boards Use
Updated 03/05/2020 | Published 03/03/2020
Question:
WHAT TYPE AND SIZE SCREW ARE NEEDED TO ANCHORE THE END CAP? ARE THE MOUNTING HOLES IN THE RUNNING BOARD TO HOLD THE ENDCAP INPLACE?
asked by: GEORGE H
0
Expert Reply:
The Replacement Endcap for Westin Sure-Grip Running Boards # 80-0221 are held in place with a #8-18x.50" phillips head screw. We do not carry this screw but you can obtain this from any local hardware store. You will want to line up the holes in the running boards with the brass fittings on the end cap and then attach with the sourced screws mentioned above.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Replacement Endcap for Westin Sure-Grip Running Boards - Front Driver or Rear Passenger - Qty 1
- Accessories and Parts
- Nerf Bars - Running Boards
- End Caps
- Westin
more information >
Continue Researching
- Article: Can You Flat Tow a 2025 Chevy Trax?
- Q&A: Parts Needed for Brake Controller Installation on a 1990 Chevy 1500 and 2003 Chevy Silverado 1500
- Q&A: Will Flat Towing 2024 Ford Maverick with Braking System Drain Battery
- Q&A: How to Install the Replacement Endcap for Westin Sure-Grip Running Boards Part # 80-0221