Could Magnetic Switch of RV Steps be Replaced by Standard Switch
Published 02/27/2020
Question:
Can a On/Off toggle switch be wired to extend my step instead of using the magnetic switch? Thank-you.
asked by: Don R
0
Expert Reply:
Yes, you could use a physical switch instead of the magnetic switch on your RV steps. Basically the magnetic switches operate in the same way as a standard switch so you'd just need to cut the magnets off of the circuits and then run them to a switch like the # D16740 which will perform the same function.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Derale Lighted On/Off Switch for Electric Fans
- Accessories and Parts
- Radiator Fans
- Switches
- Derale
more information >
Continue Researching
- Q&A: Which Trailair Air Ride Pin Box Replaces Roto-Flex 1116 Pin Box on 2018 Keystone Raptor 355TS
- Q&A: Replacement Switch for Dome Light in Camper
- Q&A: How to Wire the Derale 26 Dual Electric Radiator Fan Part # D16927 to a Manual Switch
- Q&A: Can Two MaxxFan Dome Roof Vent Be Ran Off Single Switch
- Q&A: Determining Which Light Switch Can Replace Older DF-IS001 In Camper
- Q&A: On/Off 12 Volt Light Switch That Measures 3/4 Inches Tall x 1/2 Inch Wide
- Q&A: Replacement Parts For Suburban SW6DEL Water Heater
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Lighting Requirements