Could Curt Hook with Spring Loaded Safety Latch # C81288 be Used with 1/4 inch Chain
Updated 02/17/2020 | Published 02/16/2020 >
Question:
Hello, what is the diameter of the steel rod that makes up the hook? Can it be installed on a quarter inch chain? Thanks,
asked by: Justin G
0
Expert Reply:
The thickness of the steel that the Curt safety chain loop part # C81288 uses is 9/16 of an inch. The chain you have would have to pass through a 5/8 inch opening to fit into 7/8 inch wide pocket so a 1/4 inch diameter chain would easily work with this. Check out the attached picture to see more dimensions as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Hook with Spring Loaded Safety Latch for Safety Chains and Cables - 9/16" - 5,000 lbs
- Accessories and Parts
- Safety Cables
- Tow Bar
- Trailer Safety Chains
- Safety Cable Parts
- Safety Chain Parts
- 9/16 Inch Diameter
- 5000 lbs GTW
- Snap Hooks
- CURT
more information >
Continue Researching
- Q&A: Does Karrier ST205/75R15 Radial Trailer Tire with 15" Aluminum Wheel Come Balanced
- Q&A: Will Hidden Hitch by Draw-Tite Trailer Hitch Receiver Fit a 2022 Ford Explorer ST-Line
- Q&A: How is Winch Strap of Fulton F2 Winch Accessed to Remove it.
- Article: Trailer Wiring Diagrams
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Standard 3-1/2 By 1-1/2 Stake Pocket Tie Down Anchors For Flat Bed Car Hauler Trailer
- Q&A: Safety Chain Hook that Will Work with Ford F-150 Safety Chain Loop
- Q&A: Recommended Hitch Ball For Use with Equalizer Weight Distribution Systems
- Article: Boat Trailer Guides: Which are the Best?
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review


