Overall Length and Pin Hole Distance for Replacement Male Pipe for etrailer Ram Pipe Mount Jacks
Published 01/28/2020 >
Question:
How long is the TJP-IP58-CTN and what is the distance from the near edge to center of hole?
asked by: Charles B
0
Expert Reply:
The overall length of the Replacement Male Pipe for etrailer and Ram Pipe Mount Swivel Jacks # TJP-IP58-CTN is 2-1/4 inches. The distance from the center of the pin hole to the near edge is then 3/4 of an inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Male Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 2" - 5/8" Pin Hole
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- etrailer
more information >
Continue Researching
- Q&A: Bulldog 1-7/8 Long, Weld-On Jack Pipe Mount
- Q&A: Overall Height of Round Pipe Mount Swivel Trailer Jack 7,000 lbs
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Q&A: Can Safety Chain Retainer Be Mounted On Side Of Trailer Tongue
- Q&A: How to Find Replacement Bearings for UFP Trailer Hub 13674
- Q&A: Replacement for Shelby 5101 Coupler
- Q&A: Correct Replacement for Shelby 5101 A-Frame Trailer Coupler
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Lighting Requirements
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Where to Position the Trailer Axle?


