Dexter Trailer Springs Over-Under Conversion Kit for 2020 Palomino Puma 286RBSS 5th Wheel
Published 01/22/2020 >
Question:
If the springs over-under conversion doesn't lift my trailer high enough, is there another option?
asked by: Jim
Expert Reply:
Based on my research your 2020 Palomino Puma 286RBSS 5th Wheel has axles that are in the 6,000 lb range, which means they should be 3 inch diameter round axles, though I highly recommend verifying this. Also make sure the suspension on your Palomino is double-eye spring suspension, and if so, because it is a tandem axle trailer you will need two of the Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00.
I have added a link to a video review of this kit for you to check out as well.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: Lift Kit Solution to Allow Fifth Wheel Trailer to Sit More Level When Towed
- Q&A: What Upgraded Equalizer Can I Use to Replace My 5 5/8" Long Standard Equalizer?
- Q&A: Recommended Equalizer for a 2018 Coachmen Apex Ultralight
- Q&A: Axle Lift For A 2004 Coleman Pop-Up Camper
- Q&A: Lift Kit Needed For A Big Tex 14GX Tandem Axle Gooseneck Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Lift a Gooseneck Trailer w/ Standard Axles
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Trailer Wiring Diagrams
- Article: Converting Your RV Water Heater to Tankless
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Double-Eye Trailer Suspension System Review



Jim
1/22/2020
If the springs over-under conversion doesn't lift my trailer high enough, is there another option?