Mounting Hole Dimensions for 10 inch Hook and Keeper for Enclosed Trailer
Updated 12/23/2019 | Published 12/21/2019
Question:
Are the screw holes 1inch x 2-1/4inch or 1inch x 2-1/8?
asked by: Dave
1
Helpful Expert Reply:
I went out to the warehouse and found the mounting hole measurements for the 10" Hook and Keeper for Enclosed Trailer # 37210482 to be 1" x 2-3/8".
I have attached a review video with additional measurements that you can check out.
expert reply by:
Jon G
1
Product Page this Question was Asked From
T-Style Hook and Keeper Door Holder for Enclosed Trailer - 10" Hook - Plastic - Polar White
- Trailer Door Holders
- Hook and Keeper
- Straight
- 10 Inch Long
- 1 x 2-1/4 Inch Hole Spacing
- Plastic
- JR Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement RV Waste Valves And Trailer Door Latch
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Q&A: Difference Between ST205/75D15 and ST205/75R15 Size Tires
- Q&A: Replacement Bearings and Seal for Dexter Hub 8-147
- Q&A: Comparing Kenda ST205/75R14 Radial Trailer Tires AM32161 And KE75EV
- Q&A: Difference Between Kenda Karrier K03 and KR35 Trailer Tires
- Q&A: Recommended Camera System Upgrade Using Existing Sony Wiring on 1991 Holiday Rambler Imperial
- Article: Trailer Lighting Requirements
- Article: Best RV Roof Vents
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: How to Measure for Motorhome Steps
- Article: How to Mount a Truck Bed Camper
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template