Where Should the Converter Box be Mounted on a 2006 Honda Ridgeline for Wiring Harness # 118400
Updated 05/09/2012 | Published 05/07/2012
Question:
Where is the best place to stick the Control Module on a 2006 Honda Ridgeline?
asked by: James M
0
Expert Reply:
The instructions for wiring harness # 118400, see link, do not specify it but if there is room behind the driver side tail light assembly, or a little lower, the converter box will go there. Make sure the area where it will attach to is clean so the double-sided tape will stick.
expert reply by:
Michael H
0
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Propane Manifold to Run Propane Line to Stove in Camper
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Curt 4 Flat Trailer Wiring only Getting 4-5 Volts When Testing Blinker Output.
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: 2007 Honda Ridgeline Trailer Wiring Recommendation
- Q&A: Trailer Hitch and Wiring Recommendation for 2007 Honda Ridgeline
- Q&A: Should There Be a Light On the Redarc Tow-Pro Liberty Brake Controller While Driving Without Trailer
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Hitch for a 2024 Dodge Hornet
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 7 Common Questions Everyone Has About Trailer Tires