Junction Box To Wire Lighting on Flatbed Trailer
Updated 09/16/2019 | Published 09/14/2019
Products Featured in This Question
Question:
Can I use this box to wire up all the lights on a flat bed that I am putting on my 05 Dodge 3500 ?
asked by: C B
Helpful Expert Reply:
Yes, the Pollak 10-Terminal Junction Box part # PK52248 will work to wire up the lights on your flat bed trailer. The posts on this particular junction box are not labeled so you can connect your functions to the box on any of the posts. Since you are just doing lights, you can just leave the rest of the posts unused without any issues.
You will need ring terminals part # 44-5310A to connect your wiring to the terminals.
Product Page this Question was Asked From
Pollak 10-Terminal Junction Box
- Accessories and Parts
- Trailer Wiring
- Junction Box
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Trailer ID Light Bar with 14-1/2" Hole Centers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Why Are Their 7 and 10 Terminal Junction Boxes Made for Trailer Wiring
- Q&A: Nicer Looking Aluminum Wheel and Tire Combo with Tire Size ST235/85R16 with 8 Lug Bolt Pattern
- Q&A: Is It Worth Upgrading to MORryde AllTrek 4000 From CRE3000 on Jayco 5th Wheel Trailer
- Q&A: Recommended Hoses and Regulator to Connect 100 Pound Cylinder to Main House Line
- Q&A: Replacement Recommendation For Older Ventline Roof Vent
- Q&A: Best Option to Upgrade from Bias Tire Size 7.50-16 to Radial Trailer Tire
- Article: How to Fix a Bad Trailer Ground
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers