How to Get LED Lamp # STL23R24B into # A45GB Grommet
Updated 03/27/2012 | Published 03/25/2012
Products Featured in This Question
Question:
i have purchased 4 4.5inch LED optronics tail lights to replace the standard lights these have the rubber grommet and i can not get the lights in the grommets i have pushed with all I can and they wont go in
asked by: Rob
Expert Reply:
I went out to the warehouse and pulled both the lamp you mentioned, part # STL23R24B and the grommet, # A45GB. As you can see in the short video we produced for you, the parts do indeed fit together.
The fit is kind of tight, and you will need to start the lamp into the grommet and then work your way around stretching the grommet into place around the lamp.
Soaking the grommet in hot water for a few minutes will soften it a bit and make it more pliable. You can also try lubricating the inside of the grommet with dish detergent and water to help the lamp slide in to place.
Product Page this Question was Asked From
Miro-Flex LED Trailer Light w/ Reflector - Brake, Turn, Tail - Submersible - Round - Red - 24V
- Trailer Lights
- Tail Lights
- Stop
- Tail
- Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: What is the Difference Between the Hopkins Engager Breakaway Kit # 20099 and # HM20119
- Q&A: Replacement Pin Recommendation for Fastway Weight Distribution System
- Q&A: Replacement Drop Leg 12K Jacks for a 2016 14k PJ Trailer
- Q&A: Does Sealed, 4 Round Trailer Turn Signal and Parking Light Come with Wiring Harness
- Article: Types of Bumpers
- Q&A: Does Optronics LED Trailer Clearance Light MCL66A24B Need Mounting Plate
- Q&A: Trailer Lights Available for a 24V System
- Q&A: Replacement Reverse Light for Ranger z521 Boat Trailer