Where to Install 10 Amp Fuse for Curt T-Connector on 2014 Honda CR-V
Updated 08/27/2019 | Published 08/26/2019
Question:
Where do I put the fuse in on my 2014 CRV with the fuse box under the hood??
asked by: John H
0
Expert Reply:
When installing the Curt T-Connector # C56158 on your 2014 Honda CR-V you need to access the fuse panel under your dash and put the 10 amp fuse in position 10. I have attached a photo showing this as well as an installation video that you can check out.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will Installing A Class 3 Hitch Increase The Tongue Weight Capacity Of My 2026 Honda CR-V Hybrid
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Flat Towing Set Up for a 2026 Ford Maverick Hybrid
- Q&A: Best 7-Way Wiring Harness And Brake Controller For 2024 Toyota Highlander
- Q&A: What is Required to Use Curt Echo Trailer Brake Controller
- Article: Which Hitches are Made in the USA
- Article: How to Fix a Bad Trailer Ground
- Q&A: Replacement Actuator for a Hydrastar Electric Over Hydraulic Actuator for Drum Brakes
- Q&A: Replacement Water Heater Gas Regulator for Atwood 91043
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Trailer Wiring Diagrams
- Article: Dealer Spotlight - Croft Trailer and Hitches
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)