Switching to Timbren Axle-Less Suspension for 2012 Coachmen Clipper
Updated 08/20/2019 | Published 08/18/2019 >
Products Featured in This Question
Question:
Hello, I have a 2012 coachmen clipper 16fb that we’ve recently gutted and rebuilt. It has a single 3500lb axle that I’m wanting to swap out for something rated heavier. I’m not wanting to overload my trailer with more weight I’m just wanting a little more peace of mind that the components holding up my trailer are more than enough. I would like a system in the 5k range. I know I will need new hubs/electric brakes/wheels etc but I’m wondering if axle less is a good way to go?
asked by: Jey
Expert Reply:
I have a solution for you, but the Timbren Axle-Less Trailer suspension # TASR5200S05 is not the best option because of the stiffness of the springs that this system uses. The 5200-lb Axle-less system springs are meant to carry a much heavier load than the approximately 2500-lb Coachmen Clipper, and when you use an overrated suspension system you're potentially causing way more jostling, bouncing and in turn, wear and tear on your camper.
The Timbren Heavy-Duty Axle-Less Trailer Suspension # ASR35HDS05 would be a much better fit for your application. Since this is a "Heavy-Duty" axle system, it comes with the bigger brakes and bearings that you find in the regular 5200-lb system. The difference is the softer springs to make sure your trailer isn't getting jostled around like you might find when using the # TASR5200S05 system. The # ASR35HDS05 has a 4" lift for extra ground clearance, which is another added benefit of going with an axle-less suspension system.
If you're going to be using this trailer off-road at all, and would like to use off-road trailer tires you can use # ASR35HDS02 . These offer the same Heavy-Duty setup, with a spindle that provides space for wider tire/wheel combo that you'd encounter when using special off-road tires.
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Standard Duty - 2" Lift - 5 Bolt Flange - 5,200 lbs
- Trailer Axles
- Rubber Spring Suspension
- Standard Grade
- 5200 lbs
- Spindles Only
- Universal Fit
- Lift - 2 Inch
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Increasing Ground Clearance on Trailer with Drop Spindles
- Q&A: What is the Difference Between the CM62RR, CM72RR, and CM82RR?
- Q&A: Recommended Lift Kit for Leveling 5th Wheel Trailer When Pin Box and Hitch Adjustments are Maxed Out
- Q&A: Moving Trailer Axle from Below Leaf Springs to Above the Leaf Springs
- Q&A: Measurement of Hole Spacing on Torflex Lift Kit # K71-725-02
- Q&A: Recommended 5200-6000lb Axle For M105 Military Trailer Being Converted To Overland Trailer
- Q&A: Replacement Axle Recommendation for a 2022 R-Pod RP-153
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)


