Cutting Hole in Cover to Install Extang Replacement Tail Clamp Assembly
Updated 08/13/2019 | Published 08/12/2019
Question:
How do you cut an access hole? What exactly does that mean???
asked by: Ray
Expert Reply:
To install the Extang Replacement Tail Clamp Assembly # EX1035 into an Extang Solid Fold you will need to cut a notch in the channel. A spot near the middle of the cover is preferred.
Usually you'll only need to make a notch on one side of the channel, to create an opening just large enough to both remove the original clamp and then to install the new one into the channel and then slide it back into position.
My contact at Extang indicated that usually a Dremel-type rotary tool can do this job most easily.
Product Page this Question was Asked From
Replacement Tail Clamp Assembly for Extang Solid Fold and Trifecta Tonneau Covers - Qty 1
- Accessories and Parts
- Tonneau Cover
- Clamps
- Extang Solid Fold
- Extang Trifecta
- Extang
more information >
Continue Researching
- Q&A: How to Install the Replacement Tail Clamp Assembly for Extang Solid Fold & Trifecta Tonneau Covers
- Q&A: Replacing Clamps on Extang Solid Fold Tonneau Cover
- Q&A: How to Replace the Rear Tailgate Clamp on an Extang Trifecta 2.0 Tonneau Cover
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Q&A: Installation of Replacement Tail Clamp Assembly for Extang Solid Fold and Trifecta Tonneau Covers
- Q&A: How Does Replacement Extang Tail Clamp part # EX1035 For Solid Fold Install
- Q&A: Is The Replacement Tail Hinge Cap Kit # EX35830020 Specific to The Passenger or Driver Side?
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Article: Performance Chips and Modules
- Article: Trailer Maintenance Schedule
- Article: Best Bike Racks for Electric Bikes