What Angle Do The Frame Rails Need To Be To Use the Sleeve-Lock A-Frame Trailer Coupler
Updated 08/13/2019 | Published 08/11/2019
Question:
Do you have a cad drawing or sketch to show the angle that the frame has to be for this unit to work?
asked by: Chuck
0
Expert Reply:
The Sleeve-Lock A-Frame Trailer Coupler part # CA-5296-B is designed for a standard 50 degree a-frame trailer. If you have an a-frame trailer then this is likely what you have as I would say a good 95% of a-frame trailers use the standard 50 degree angle. I don't have any CAD drawing of the above unfortunately but let me know if you do not have the standard 50 degree angle.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Sleeve-Lock A-Frame Trailer Coupler - Flip Latch - Black - 2-5/16" Ball - 12,500 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 12500 lbs GTW
- 2-5/16 Inch Ball Coupler
- Flip Latch
- 2-1/4 Inch Hole
- Standard Grade
- etrailer
more information >
Continue Researching
- Article: Which Hitches are Made in the USA
- Shop: Sleeve-Lock A-Frame Trailer Coupler - Flip Latch - Black - 2-5/16" Ball - 12,500 lbs
- Q&A: How to Prevent Hitch Pin Hole Deformity
- Q&A: Height Of Side Mounting Brackets For B&W Heavy-Duty Trailer Hitch Receiver # BWHDRH25124
- Shop: Trailer Hitch
- Shop: Brake Controller
- Search Results: bulldog couplers gooseneck trailer locks
- Video: Ultimate Overview of the A-Frame Trailer Coupler w/ Round Jack Hole
- Video: Checking Out the Bulldog Collar-Lok Coupler w/ Low-Profile Latch
- Shop: Curt QuickPin No Latch A-Frame Trailer Coupler w/ Jack Hole - 50 Degree - 2-5/16" Ball - 14K
- Shop: Bulldog Collar-Lok Coupler w/ Low-Profile Latch - 2-5/16" Ball - A-Frame - 12,500 lbs
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Westin Fey Diamondstep Rear Bumper with Custom Installation Kit - Black Powder Coated Steel
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 7' Long x 14" Wide - 6,000 lbs
- Q&A: What Is The Narrowest A-Frame Coupler For Trailer?
- Q&A: Hardware Needed to Install etrailer E-Track on Trailer Floor
- Q&A: Capacity of etrailer Horizontal E-Track e42VR
- Q&A: Recommended A-Frame Coupler for Flatbed/Car Hauler Trailer
- Q&A: Which Latch is Easier to Operate on the Bulldog Collar-Lok Coupler
- Search Results: jack swivel mount