LCI Solera Power Awning Blows Fuses When Powered 1/2 Way Out Troubleshooting
Updated 08/05/2019 | Published 08/03/2019
Question:
We have a 2018 Keystone Cougar 26SABWE. The Solera power Awning worked fine a few weeks ago, then this weekend camping it blew a fuse when trying to extend it. Replaced fuse tried again and blew it again. Replaced fuse again and was able to retract it back into place and fuse was fine.. what do we need to do to fix this?
asked by: Karla J
Expert Reply:
Normally this happens when the awning is binding up as it's powering out. Check to make sure that it's powering out level from left to right as it's very possible that one side is higher than the other which is causing the awning to not roll up squarely and eventually bind up. This is almost always the issue when an awning motor wants to blow fuses when before it fully powers out.
Product Page this Question was Asked From
Replacement Motor for Solera Power RV Awnings Manufactured before 2015
- Accessories and Parts
- RV Awnings
- Motors
- Solera Replacement
- Lippert
more information >
Continue Researching
- Q&A: Lippert Solera Awning Blows Fuse When Trying To Extend Arms
- Q&A: Lippert Solera Awning Instantly Blowing Fuse
- Q&A: Will Replacement Fabric for etrailer Powered RV Awning Work With Solera Or Dometic Awnings?
- Q&A: Best Replacement for a Dometic Blizzard 15,000 BTU Air Conditioner
- Q&A: Does The Onan Generator Quiet Series 4000 CM32ZR Include A Gas Tank?
- Q&A: Installing Lippert Components Solera Power Awning Replacement Motor
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Holiday 2025 | Best Gifts for Towers
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Flat Towing Package for 2010-2013 Chevrolet Equinox
- Article: Demco Vehicle-Specific Base Plates