How Does Light with 1 Wire Ground
Updated 07/29/2019 | Published 07/26/2019 >
Question:
My over head light in my truck went bad it has two wires but my new light only has one wire how do I hook up my new light to my wires thanks
asked by: Danny S
Expert Reply:
When a single function light only has 1 wire, like the Thinline LED Trailer Clearance or Side Marker Light # MCL67AB, it means that it grounds through the mounting hardware. If the mounting location doesn't have a clean, bare-metal surface then you either need to clean it for a good ground connection or find an over head light that uses 2 wires for installation.
Product Page this Question was Asked From
Thinline LED Trailer Clearance or Side Marker Light w/ Bracket - Submersible - 3 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 1W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Will Self-Contained Hydraulic Jack Fit Maxx-D DTX 16k Dump Trailer
- Q&A: Replacement Trailer Clearance Light for GloBrite 1250
- Q&A: 16 x 6 Dually Wheels with 4.88 Pilot Hole and 8 on 6-1/2 Bolt Pattern
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Replacement Fireplace for a Furrion FF40SC15ABL
- Article: Trailer Lighting Requirements
- Q&A: Recommended Center Cap for a Aluminum AM03 Series Black Machined Trailer Wheel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Winch Mounting Plate Needed for Aluma 82 Series Car Hauler Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Fix a Bad Trailer Ground
- Article: Trailer Maintenance Schedule

