Trailer Hitch Plastic Cover for a 2004 Jeep Grand Cherokee
Published 06/08/2009
Question:
my 2004 grand cherok has a plastic cover that covers the entire back under carriage how do i install a hitch with this cover? where is hitch made?
asked by: Scott B
Expert Reply:
For these hitches, you will see that the plastic skid shield (cover) will remain in place, sandwiched between the hitch and the frame. We have 5 hitches that will fit your vehicle, for your convenience I have provided a link to each of the custom fit hitches we carry.
Most of our hitches are made in the USA. Some of the Hidden Hitch models are made in Canada.
Keep in mind that when you pick an option that fits your needs you may also need a draw bar, pin & clip, ball, and a wiring harness. All of these items will be suggested on the page with the hitch of your choice.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Install The Curt T-Connector Wiring Harness In A 2002 Jeep Grand Cherokee
- Article: Trailer Wiring Diagrams
- Q&A: Do You Need To Disconnect The Battery On A 2019 Cadillac Escalade While It Is Flat Towed
- Q&A: Is There A Factory Type Hitch For My 2004 Jeep Grand Cherokee?
- Q&A: Big Tex Trailer Ramp Replacement Springs
- Q&A: Replacement Hardware For Curt Trailer Hitch Receiver # 13051 For a 1999-2004 Jeep Grand Cherokee
- Q&A: Recommended 5.30-12 Tires With Load Rating Of D
- Article: Trailer Hitch Installation Tips
- Q&A: How to Prevent the Trailer Hitch from Scraping the Ground on a 2015 Subaru Legacy
- Article: How to Measure for Trailer Hitch Drop